Torque Spec Valve Cover Tightening Sequence
Valve Cover Gasket- Torque Specs and Order. Engine: bored out 305. The most important thing to watch for on this job is to be sure not to drop any shit onto the cams when removing the cover and cleaning the mating surfaces. 09-08-2015 07:07 PM. Other than that the job is just about the same. 68 Impala, 15 SantaFe. I jsut got some new valve covers and i cant find the chilton manual to tell me the torque that they should be on there any1 have that information or somewhere online i can find it? Location: Providence, RI, USAVehicle: 2018 Crosstrek CVT. The rtv holds the gasket to the valve cover's smoother gasket surface. Torque for valve covers. The nuts and the bolts for the collector go in at 8 ft-lbs in the following order. There possibly is a setting somewhere, but honestly I have never bothered.
- Torque spec valve cover tightening sequence youtube
- Torque spec valve cover tightening sequence
- Torque spec valve cover tightening sequence kit
Torque Spec Valve Cover Tightening Sequence Youtube
Start all the bolts a few threads by hand, and then run them down with the socket till they just barely touch the cover. What I don't mention in the video is the intake collector bolts/nuts and what the order and spec are for those. Common sense is the main thing here really.
Torque Spec Valve Cover Tightening Sequence
To confirm, it is 7 ft-lbs, correct? The turbo DOHC has directions on where to apply liquid gasket. It's not a critical thing. © 2001-2023 Audizine,, and. 43. i use a socket on a screwdriver style handle, works good as theirs pretty much no way to over torque them that way. Not too tight, but not loose either. The thick gaskets are forgiving, effective, and keep the valve cover comfortably away from the rockers (if you have aftermarket rockers, this is a concern). BEW valve cover fastener torque sequence. Flat head screw driver. 09-13-2015 07:44 AM. All it says is to use a new gasket and install the gasket to the cover.
Torque Spec Valve Cover Tightening Sequence Kit
Values in the chart are given in N*m). 3 years since i have had them off and no leaks. Axle/Gears: stock pegleg 2. Yep, which is why they always leaked over time and people used gasket sealer to prevent it. Torque spec valve cover tightening sequence youtube. As a refresher here are the order and the specs for the valve cover and the throttle body: 2 Rounds of torque. Location: Toledo, OH. Use RTV on the valve cover side, and throw on a re-usable FelPro gasket on each. I've seen it a hundred times over the years. If you still have the info handy are there any recommendations as to where to place the liquid gasket? To be I'm not trying cast aspersions on anyone in particular... I simply tighten them a tad over firm, or as the Americans say, "just snug them up".
Location: Centennial, ColoradoVehicle: 08 Impreza, 80Vette. Forgot your Password? Same for both sides. I realize it's an old thread, but ran across this doing some cam-cover research and thought I'd add the answer according to that there's anything at all wrong with the sage advice posted by Grand and Doug! Torque spec valve cover tightening sequence kit. Chapter/Region: NESIC. Do Not Sell or Share My Personal Information -. Do those t-belt end bolts last, and just barely snug them down. The only downsides are if your space is limited and sliding the valve cover down over the studs is difficult or impossible.
Actual spec is like 6 ft-lbs or something. In order to log in after the forum software change, you need to reset your password.